電源接入端應裝備總開關，主機和控制箱均要可靠接地 模拟运输振动台安装
1、前檢查電源應駁正確,可靠接地
2、打開電源開關，輕按一下啟動按扭，馬達開始工作
3、調節速度旋鈕至所需速度(在空載時設定所需要速度,所測物放入實驗台.)
4、 設置好測試時間， 關掉時間開關重新啟動。
5、放好待測物品並夾緊
6、旋開爭停開關，開始測試
7、測試完成後，自動停機
8、取下測試品進行檢查
Simulation of the transport vibration table use
Is specially test electronics, electrical appliances, motor, household appliances, vehicle, aviation, communication, etc. Finished products or components of the degree of resistance to vibration. To understａnd all kinds of equipment in a certain frequency and amplitude of vibration, quality or structure, impact and change that export products to do compare transport vibration test of the product.
Transportation vibration table installed
1, this machine should be installed in a dry, solid, level off the site
2, good AC220V 50 hz
3, the location of the place the tester on the wall, and every other good rubber
4, ground leveling, make motor cooling mouth outwards, and control box
5, even a good motor line and control line
6, connected to the power supply should be equipped with master switch, host and control cabinet shall be reliable grounding
Transportation vibration table installed
1, check before starting the power supply should be lighter, right and reliable grounding
2, open the power switch, gently press the start button, motor start work
3, adjust the speed knob to the required speed (in no-load speed setting when needed, the measured object into the test bench.)
4, set up test time, off time to restart the switch.
5, put the items under test and clamping
6, unscrew the stop switch and start testing
7, after completion of test, automatic stop
8, remove the test items for inspection
